Manual/Auto Start Controller

The DSE3110 can be utilized as a Manual or Auto Start Module for single generating set applications and forms part of DSE’s next generation of control modules. The module has been designed to work with electronic and non-electronic engines providing advanced engine monitoring and protection features.

The DSE3110 includes a back-lit LCD display which clearly shows the status of the engine at all times. The module monitors engine speed, frequency, voltage and run hours and also displays the warning and shutdown status of the engine.

The module includes six digital inputs and four outputs. The module can either be programmed using the front panel or by using the DSE Configuration Suite PC software.

The module is available in two variants: Magnetic Pick-up and Canbus.

Main Features

• Back-lit LCD display
• Remote start input
• Electronic engine enabled
• Magnetic pick-up
• Full engine monitoring and protection
• PC programmable
• Protected Solid State Outputs (PSS)
• 6 Digital inputs
• 4 Outputs (2 configurable on magnetic pick-up version, 4 configurable on Canbus version)

Benefits

• Hours counter provides accurate information for monitoring maintenance and warranty periods
• Multiple engine parameters are monitored simultaneously
• Suitable for engine only applications
• Module can be configured to suit individual applications
• IP65/Nema 12 rating offers advanced resistance to water ingress (Gasket required)
• No need for additional metering equipment
• Wide range of engines can be specified
• Uses the DSE Configuration Suite PC Software for simplified programming

Operation

MANUAL MODE

• The engine is started using the Start button on the front of the module
• Once pressed the module instructs the engine to initiate its pre-heat sequence and then start the engine
• To stop the engine the Stop button on the front of the module should be pressed

AUTOMATIC MODE

• The Auto button needs to be pressed to put the unit in Auto Mode
• The module start sequence is initiated by the activation of the remote start input
• The pre-heat sequence is then initiated and the engine is started
• To stop the engine the remote start signal needs to be removed or the Stop button on the module needs to be pressed

Important Notes

Electronic Engine Compatibility

• CAT
• Cummins
• Deutz
• John Deere
• MTU
• Perkins
• Yangdong
• Scania
• Volvo
• Generic
• Plus additional manufacturers

Auto & Manual Start Control Module

The DSE701 is available in Manual and Auto Start versions, offering an excellent range of engine monitoring and protection features.
The module has been designed to monitor low oil pressure, high engine temperature, over speed and a user defined auxiliary input.
It also has the capability to monitor battery charging by utilising the WL terminal on the charge alternator. When the module detects a fault condition it automatically shuts down the engine.
The DSE702 is available in Manual and Auto Start versions including all the features of the DSE701 plus a tamper proof engine hours counter.
Both modules include a remote start signal input. This input allows the module to be started from a pre- defined remote location.

Main Features

• Manual start
• Engine pre-heat
• Engine monitoring and protection features
• Protected solid state (PSS) outputs
• Front panel mounting
• Remote start
• LED indicators

Benefits

• Multiple engine parameters are monitored simultaneously

Operation

Manual Mode:

• The module is started using the on-board key/buttons
• The user turns the key to the hand position
• The engine pre-heat button is then pressed for the required time
• The start button is then pressed to start the engine
• To stop the engine the key needs to be turned to the off position

Automatic Mode:

• The key needs to be permanently left in the hand position
• The module is powered up by the remote start signal
• The pre-heat function is automatically carried out and then the engine is started
• To stop the engine the remote switch is turned to the ‘off’ position

Important Notes

• When ordering you must specify whether you require the Manual or Auto version.

Alternative / Associated Products DSE702 – Auto & Manual Start Control Module