Print This Page
10,000 Watt Diesel Power Generator
Small, Simple and Effective Diesel Industrial Generator
This small industrial 10 watt diesel generator has all the same features as our our larger generators just without the enclosure. Using approximately 0.5 gallons of fuel an hour under full load it is very efficient and cost effective. This generator comes with a built in belly fuel tank, battery and digital generator controller.
$3,999.00
This 10 kw diesel generator ( 12 kVA ) was developed for those who need dependable backup power without paying more expensive enclosures. It supplies a little less power then traditional enclosed units but far better for supplying backup power then a portable generator. The engine is the same model used in farm tractors around the world. You can expect over 10,000 hours of use out of this water cooled 1800 RPM engine. Many people install this 12 kva diesel generator a garage, shed or beneath an overhang.
Highlights
- Built-in belly fuel tank
- Maintenance Free Brushless Alternator
- Automatic Voltage Regulator
- Includes Muffler
- Digital Generator Controller
- Powerful 3 Cylinder 1800 RPM Engine
- Battery
- EPA Approved
- Cold Start Preheater
Alternator / Generator
- Single Phase 120 and 240 volts
- Can be used for either 50 Hz or 60 Hz use
- Brushless Type
- Uses an Automatic Voltage Regulator
Generator Controller
The GU601A is a microprocessor controlled Automatic Generator Controller for Home Generators and Standby Generators. It can be used in either automatic or manual modes. Both modes are selectable from the front panel. In automatic mode it can be triggered by remote signals such as a loss of power or automatic transfer switch. The LCD display shows generator operational status and parameters. Its main characteristics as below
- Protective parameters can easily be configured via panel input and menu system or by software, USB cable and PC
- Controller can measure and display Alternator Frequency, Alternator Voltage, Battery Voltage, Oil Pressure and Coolant Temperature.
- Built in hour meter.
- Set fuel mode to normally closed or normally open mode.
- 5 relay control output Fuel and Start Crank relay outputs
- 3 of the 5 outputs are configurable
- Oil Pressure and Engine Temperature Inputs
- 3 configurable inputs
- All connections of controller are connected by pin locked up terminals, easier and more convenient to connect, move, maintain and replace the device.
| Generator Model Number | AGI10X-open – 12 kVA Generator |
| Manufacture | Aurora |
| Rated Speed / Frequency | 1800 rpm / 60 Hz 1500 rpm / 50 hz |
| Prime Output Power | 9,000 Watts |
| Standby Output Power | 10,000 Watts / 14.4 kVA |
| Voltage / Phase / Wire | 120 & 240 Volt Singe Phase |
| Power Factor | 0.8 (lag) |
| Rated Alternator Output Current | 42 Amps (240 Volts) 84 Amps (120 Volts) |
| Dimension (W * H * L) Without Feet | 2.5′ feet Wide 3.5 feet Tall 4.9″ Deep |
| Wooden Crate Dimensions | |
| Net Weight | 450 KG | 992 lbs |
| Diesel Engine Model | |
| Engine Character | 3 Cylinder Water Cooled, 4-cycle, Direct Injection |
| Altitude | Not indented for use above 3000 feet |
| Bore (mm) x Stroke (mm) | 85 mm x 90 mm |
| Fuel Consumption | g/kw.h 247 |
| Included Belly Tank | 50 L | 13.2 Gallon |
| Lube Oil Capacity | |
| Cooling Water Capacity | |
| Start Model | Electric |
| Speed Governor | Mechanical |
| Alternator Type | Leroy Somer Brushless Single Phase |
| Insulation Class | F |
| Protection Class | IP22 |
| Efficiency | 92.8% |
| Voltage Adjust Range | 6% |
| Steady Voltage Regulation | 1% |
| Voltage Regulation | Automatic Voltage Regulator |
Optional – 200 Amp Transfer Switch $349.00
A transfer switch allows safely switching from utility power to emergency generator power while maintaining isolation of each source from the other. The switch may be either a manual switch, an automatic switch, or a combination of manual and automatic. In a home during a power outage, for example, the transfer switch allows isolation of the owner’s critical circuits (e.g. cooling, refrigerator, lighting) from the utility service, allowing for operation of the generator without back-feeding to the utility, which can damage utility equipment and hurt (or kill) utility workers.
Most homes in North America have 200 amp rated electrical service. To switch the whole home on and off the main power grid and safely direct it to your generator this transfer switch is recommended.
Transfer Switch model number TWB2005DR
This Panel/Link TWB includes a 200A main circuit breaker interlinked with a 50A generator breaker feeding a heavy-duty copper bus with feed-through lugs. The interlinked circuit breakers keep the generator isolated from the utility at all times, even with the deadfront removed. The TWB is suitable for service entrance and may be used as a main panel or feed-through to a sub-panel or main panel. The TWB has provision for 4/8 branch circuits and is ideal for applications requiring the entire service panel to be available for generator power.
|
