USA & Canada

* Financing Available

How Do I Automatically Start My Generator?

How Do I Automatically Start My Generator?

Setting up Auto-Start on an Aurora Generator with a DynaGen Controller is simple. Here is how it works. With the generator set to "auto", it will remain on standby until PIN 7 on the din terminal block is connected to ground PIN 9.

There is no power needed here. Just a dry contact from a relay on your ATS or remote that closes a connection to start and opens it to stop. That's a two-wire start.

For advanced installations, if auto-start should happen when a "Float, Open, Battery or Ground connection is made instead, it can be configured in the DynaGen Controller Menu.



How to setup Auto Start on your generator

Previous Post Next Post

  • Aurora Generators
Comments 0
Leave a comment
Your Name:*
Email Address:*
Message: *

Please note: comments must be approved before they are published.

* Required Fields