Menu
Cart 0
Generator Battery Smart Charger | 6 Amps

Generator Battery Smart Charger | 6 Amps

  • SKU # 28106



This 28106 model is a 1 bank, 6 amp, 12V DC output charger with wide input voltage range (100-240V AC), is microprocessor controlled and has a maintenance mode that will keep the charger fully charged. The Marinco 28106 meets the CEC (California Energy Commission), FCC, CE, is RoHS compliant and has UL and CSA listings (cULus). The 28106 has the same mounting dimensions as the Guest 2608A and 2608A-B and replaces these models.

Dimensions

  • Height 3.5 inches 8.89 cm
  • Width 6.4 inches 16.26 cm
  • Depth 2.42 inches 6.2 cm

Mounting

Mounting Bulkhead mount (vertical at wall) Hole diameter is .245 inches / .622 cm or clearance for #10 screw Left to Right Center to Center = 5.671 inches / 14.40 cm Top to Bottom Center to Center = 1.465 inches / 3.72 cm

Weight

Approximately 4.0 lbs. (1.8 kg)

Connection

  • AC 6’ (1.8 m) AC Cable with NEMA L5-15P AC Plug. Cable consists of 18/3 SJTOW cord with one BLACK (HOT), one WHITE (NEUTRAL) and one GREEN (GROUND)
  • DC 4’ (1.2 m) DC output cable, 18 gauge wires, SJTOW with ring terminal connection

Charge Indicators

Unit has 2 LEDS, one Red and one Green in color. The following table should be used as indicator of the charger status

  Red Green
Soft Start On Off
Bulk On Off
Absorption On On
Float Off On

 

Protection

  • Ignition Protection
  • Over Current
  • Over charge
  • Reverse Polarity
  • Thermal Protection
  • Short Circuit

 

Temperature Characteristics

  • Ambient Operating Temp Full Power - -40 °C to 50 °C
  • Storage Range - -40 °C to 70 °C

 

SPECIFICATIONS 

Battery Recommendations
Battery Size: Group 24 through 31 (up to 120 Amp-Hr)
Battery Type: 12V lead acid (FLOODED and AGM)
Maximum Recharger Time: 12 Hours
Input Voltage Range 100 - 240 Volts AC 50/60 Hz.
Input Current Rating 2.0 Amps Maximum
Voltage / Current
Bulk Charge Rate 5.5-6.5 Amps
Absorption  3-6.5 Amps
Float  0-3 Amps

Soft Start

Soft Start - “Soft Start” slowly charges the battery with 14.25V (10% of rated current). As soon as the max Soft Start timer (starts immediately when entering “Soft Start”) of 6 hours is reached or when the battery reaches 10V for 30 seconds the charger switches to the “Bulk stage”

Bulk

Bulk - “Bulk” charges the battery with 14.3V (100% of rated current) until the battery reaches 13.25V. As soon as the battery reaches 13.25V the Bulk timer will start counting after which it can charge the battery up to 12 hours until the voltage reaches 14.25V. As soon as the max Bulk timer (starts when voltage level is above 13.25V while in “Bulk”) of 12 hours is reached or when the battery reaches 14.25V for 30 seconds the charger switches to the “Absorption stage”

Absorption

Absorption - “Absorption” charges the battery with 14.25V. As soon as the Absorption timer (starts immediately when entering “Absorption”) reaches 14 hours or when the charge current drops below 10% of the rated current for 30 seconds the charger switches to the “Float stage” 

Float

Float - “Float” keeps the charger on a specific voltage level of 13.25V (100% of rated current) for a period and then will switch to the “Maintenance stage”

Maintenance

Maintenance - As soon as the re-cycle timer reaches 14 days (336 hours) or when the voltage drops below 12.8V for 30 seconds the charger switches back to “Bulk stage”

Certifications

 

      • cULus - ANSI/UL 1236 "Battery Chargers for Charging Engine-Starter Batteries" E227501
      • ABYC - American Boat & Yacht Council = UL 1236 marine section A20 (Battery Chargers), E8 (AC Systems on Boats), E9 (DC Systems on Boats)
      • CE - 2006/95/EC (safety directive) , EN 60950-1:2006 + A11: 2009 + A1:2010 + A12:2011 applied for 230V models
      • CEC - CB Mark for 120V
      • FCC - Labeled, FCC Part 15 Class B EN 55022
      • RoHS - Compliant
       

 

Generator Battery Charger 6 Amp